The Bukan Pipe training unit holds an inter-workshop training centre licence, number 14/11221, from the Technical and Vocational Training Organization (Ministry of Cooperatives, Labour and Social Welfare). It was issued on 1404/07/23 in the Iranian calendar and runs for five years. Its legal basis is Note 2 of Article 110 of the Labour Law and the regulations governing adjacent-workshop and inter-workshop training centres.
What an inter-workshop centre means
An adjacent-workshop centre trains the staff of its own factory. An inter-workshop licence permits training for employees of other industrial units in the province as well. The practical difference is that another contractor or employer can send their own people here.
Why welding training is taken seriously in polyethylene
On a PE line the joint is where failure starts, and a defective weld usually looks sound. The commonest cause is releasing the clamp before the cooling time has elapsed — the joint appears correct but fusion is incomplete. This is why, in gas networks, welder qualification and a weld record are part of the requirements for handing over the line rather than a formality.
Related subject matter
- Butt fusion: parameters, surface preparation, alignment and cooling time
- Electrofusion: scraping the oxide layer, seating the fitting and keeping the assembly undisturbed
- Visual inspection of joints and recognition of common defects
- Pipe quality control: dimensional inspection and laboratory testing
- Safety around fusion equipment and in the trench
Syllabus, course length and enrolment terms depend on the group and are arranged through factory contact.
FAQ
- Is Bukan Pipe's training licensed?
- Yes. The training unit holds inter-workshop training centre licence 14/11221 from the Technical and Vocational Training Organization, issued on 1404/07/23 with a five-year validity.
- Can staff from other companies attend?
- Yes. The licence is of the inter-workshop type, which permits training for employees of other industrial units in the province, not only the factory's own staff.
- What does a polyethylene welding course cover?
- Butt fusion and electrofusion, surface preparation and cooling time, visual inspection of joints and recognition of common defects, pipe quality control, and safety. Exact syllabus and course length depend on the group.